Mega tree+ ch stuck...
 
Notifications
Clear all

Mega tree+ ch stuck on

5 Posts
3 Users
0 Reactions
2,900 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
[#17947]

Well this has been a minor issue where 1 ch sticks on, Usually fixes it self with the blow dryer now seems not anymore. So I am wondering if I should just leave it on or move over that ch to another, It is ch 5 so move 1 strand to 4 and 1 strand to 6. That puts me over a bit I would be at 12.54amps on that side. I do have heatsink. I just hate seeing it on esp. on the mega tree. I will prob move it just curious.

Thanks
John


4 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

Do you have a spare channel? If you have a spare channel, just move the one and change the output in Vixen.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
Wayne J wrote:Do you have a spare channel? If you have a spare channel, just move the one and change the output in Vixen.

I think I do not on the same controller, But just a extension cord. Is it easy to change the output? Never done that before.
That never even crossed my mind to move to another ch so easy but thanks for the spark.

John


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
olingerjccj wrote:I think I do not on the same controller, But just a extension cord. Is it easy to change the output? Never done that before.
That never even crossed my mind to move to another ch so easy but thanks for the spark.

John

Easy? yes and no. No matter what you do save a copy of your sequence/profile before you change the outputs. Also, don't simply move the unused one. You have to swap them. Otherwise everything after the busted one will be off by 1 channel 🙂


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago

I went the easy way. I have 11 songs so i just used the copy full events and added that to the good ch I had on each song took like 3 mins. Since it was just 1 ch not too much work. Fired it up and looks much better.

Thanks
John


Reply
Share: