DirkCheap Topper
 
Notifications
Clear all

DirkCheap Topper

6 Posts
6 Users
0 Reactions
3,277 Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
[#20320]

We're on a cost-cutting effort here at DIGWDF, and the engineers have collaborated on a new topper for our new 16' megatree. (Actually, they didn't so much collaborate as they somehow sneaked out of the lab and up into the garage where the power tools, PVC, ropelight and installation supplies are stored...)

They came up with this thing.

The trunk of the tree is a set of four fibreglass military tent poles, each is hollow and 4' in length, so they used some 2" PVC which barely fit around the top of the reinforced section of one of the poles and cut off a short collar. They drilled 24 holes around the PVC collar and inserted zip-ties to hold the light strings (To their credit, they left the zip ties open...) and fastened it to the tent pole with four short machine screws. They found an old cutout from one of our plywood stars and wrapped some ropelight around it using zip-ties to fasten the ropelight to the plywood. To hold the star to the pole, they cut a notch out of another section of the 2" PVC and slid it on either side of the star, fastening it through the star with a single 1/4-20 bolt and wing nuts. They dropped the wire for the ropelight down through the hollow pole and connected the star to the top of the pole with a 2" PVC joint, screwing a couple short sheetmetal screws into the joint to hold it securely.

We found them passed-out on the garage floor with several empty cans of black spray paint, so we'll have to get to that later... but for now, we managed to drag the engineers back downstairs and to the lab where they belong... some of them may hurt a little bit when they wake up, but on the other hand, they may not remember much, either...

DSCI0861b
DSCI0851b
DSCI0854b

5 Replies
lightman
Posts: 1524
(@lightman)
Noble Member
Joined: 19 years ago

Looking good Dirk!

Regards,
Lightman


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

Just.think what the engineers could come with if they found your stash of lutefisk! The mind boggles...


Reply
FIRECOP252
Posts: 1292
(@firecop252)
Noble Member
Joined: 16 years ago

Dirk....the things you come up with....WOW...looks good!!!


Reply
THurrle
Posts: 1211
(@thurrle)
Noble Member
Joined: 17 years ago

Is that lutefisk washed down with Leinenkugel's?


Reply
Mactayl
Posts: 2491
Guest
(@mactayl)
Member
Joined: 17 years ago

Nice looking topper there Mr. Dirk


Reply
Share: