32 Strand Single Co...
 
Notifications
Clear all

32 Strand Single Controller Wiring

13 Posts
6 Users
0 Reactions
6,871 Views
toy4x4
Posts: 25
Topic starter
(@toy4x4)
Eminent Member
Joined: 13 years ago
[#47042]

Looking for a plan/tutorial/documentation where someone has wired up 32 strands to 16 outputs? I need some ideas on how to do this the best way.

]If needed, I'm using 5V 2811 bullets.


12 Replies
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

String 1 & 2 connect together as one long string, so it will go from the bottom to the top and back down Output 1, power inject at the end of string 2
String 3 & 4 ..... Output 2, ....
.
.
.
String 31 & 32 connect together as one long string, so it will go from the bottom to the top and back down Output 16, power inject at the end of string 32

Then either in the controller setup for each output you tell it to ZIG-ZAG @ ## (I assume 50 as you say you have 32 strings) or in the sequencing software, when patching the strings to the controller, you will need to reverse the 2nd strings so they will logically run from the top down.


Reply
toy4x4
Posts: 25
Topic starter
(@toy4x4)
Eminent Member
Joined: 13 years ago

Thanks!


Reply
Posts: 431
(@dkelly0802)
Honorable Member
Joined: 11 years ago

Would you carry the data over from one segment to the next or Is there no reason to do that? Just fresh pos neg and data on each port?


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

No, don't carry over data, each output sends the data for the strings connected to that output.


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago

I have a 24 string tree using 4 outputs. Ruppo is correct in how I did it. I use 1 output for 8 strings, I inject every 100 pixels for 12v pixels, use zig zag, I use xlights. Then 1 channel for the 6 ring 270 pixel star.


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago

Here is a pic of my setup. D is data, A1-6 is power inject.


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago

I tried to add a pic but it does'nt seem to attach. Website problems?


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
aknflyer wrote:I tried to add a pic but it does'nt seem to attach. Website problems?

Double check size and file type.


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago
aknflyer wrote:Here is a pic of my setup. D is data, A1-6 is power inject.

Trying again. Did'nt work is just a 184kb file now. When I manage uploads just get a white box.
Here is a dropbox link for my wiring:

Dropbox Logo Dropbox File (Private or Invalid)

Hope it helps someone.


Reply
Page 1 / 2
Share: