I am going to put together my matrix, but can't find which way to start it. I did see somewhere the first pixel is lower left corner, is this correct? Then I will zig-zag up?
Going to be 30 pixels wide x 15 high, cutting pixel strips 1 meter long, then zig zag up.
Thanks for any info!
How it's wired is really irrelevant. That's the whole point of patching. But in the preview, matrices start in the lower left. So it's best to set up your elements and groups like that in vixen for ease of sequencing, and then you can patch those elements in any order as necessary to match how your physical device is wired. Naturally, if you build the physical to match the layout on screen, it'll be easiest and most straightforward to do the patching later.
By the way: it's easiest to not zig zag. So if you don't have to for electrical reasons, it's best to do it straight. Second best if you must zig zag is to handle the zig zag in the controller as opposed to in software. With the small size of the matrix you're describing, it shouldn't be a problem to keep all the strips in the same direction and just bring the data lines back from the top of one column to the bottom of the next.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
Thanks, that's what I needed to know. Going to start working on it now!
Keep up the great work with Vixen!!!!
