OK - i have 2 problems - my matrix has 2 even strings which end after several zig zags at the bottom of my 42 by 21 (882 pixel) matrix.
These ones are easy to patch.
But the other 3 strings - are shorter and don't end on that number. in fact some start half way up for example.
I am wondering if i should put each of the other ones on a different back of my e682 (i could do this with a seperate one for each) - and start the universe numbers somewhere far apart. Is that the best way?
Also -not really sure the best way to set up the controller in vixen 3? I have set up many outputs (see attached) but not sure how many should be set up? for example the 2 even strings are 252 pixels each - and I've coded for that on the e682 - it says if i use 4 it goes to universe 6 0- is that correct and how should i align vixen to the e682?
Thanks so much - 1st display here!!
First reply disappeared so gonna try again..
Starting off with I am a complete newbie myself, no real world experience, just doing a ton a research, to include the e682 controller as that is what I am planning on using in my first display.
Going off of your config page on the controller webpage screenshot, you only have group #4 enabled, using all 4 outputs, and have it addressed with 252 pixels on each output, so the controller is using the starting universe and adding the required channels and ending in the universe that it took to get the channels.
252 pixels is quite a bit for a single string. Is there any reason you would run such long strings and then use a few short ones in the end? The power injection, slow data rate and work to get it patched in doesn't seem worth it. I would try to break the strings down into 8 (110-111) string pixel strings and use two groups of outputs to control it. It would get rid of power injection needs, make data rates a lot better, and make patching/sequencing more natural. Not sure why you would have the first three groups inactive either.


