Multiple P10 matric...
 
Notifications
Clear all

Multiple P10 matrices?

54 Posts
14 Users
0 Reactions
22.1 K Views
brianweb
Posts: 245
Topic starter
(@brianweb)
Reputable Member
Joined: 13 years ago
[#39938]

I am trying to wrap my around around these new fancy P10 boards. I understand I will need a BBB and octoscroller, and can run it from a Pi. I have two upstairs bedroom windows, about 4' X 3' that I wanted to each have a matrix.

Is there a way to have the BBB and octo thingy drive two separate matrix that are probably 10 to 15 feet apart? Or do I need a bbb/octo combo for each matrix, at which point it might make sense to just do the old fashion bullet pixel matrix?

Thanks,

Brian


53 Replies
Posts: 252
(@vincerules)
Reputable Member
Joined: 14 years ago

I'm not sure about the distance thing... hopefully someone else will chime in on that, but my opinion is it would be better to get a 2nd bbb/octoscroller (if it is needed) rather than using bullet pixels. For the resolution you get at 11 bucks a panel, it would cost a lot more to do that with bullet pixels. Each panel is 512 pixels.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

should ask this question over in the falcon christmas forum:biggrin2:


Reply
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

Why not use one of RonP's controllers....
You can run up to 32 P10 panels from his 64 universe controller.
http://ronsholidaylights.com/64-universe-controller/
You can find him over at www.diychristmas.org
I use one of his 16 universe controllers to run my small P10 matrix 3X2, :yay:
He has group buys on his controllers from time to time.


Reply
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago

Let's say... hypothetically... I want to build a 10x10 matrix using 100x P10 panels.

What is the best controller for that? Or do I have to use multiple controllers?


Reply
Page 1 / 11
Share: