Looking for some St...
 
Notifications
Clear all

Looking for some Strobe LED knowledge

11 Posts
4 Users
0 Reactions
5,753 Views
dirknerkle
Posts: 10311
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
ChiefWarrant wrote:Thank you Dirk,

I have 1N4001's and some 10 Ohm resistors on hand. I am going to hit the Shack and get some LM317's to start fabing some of these to test with the SSR12's

On your trip to RS, pick up some 8 and 9 ohm resistors too, if you can. Contrary to what seems logical, a higher resistor value actually will increase the current to the LEDs. While 10 ohms is pretty low, it's amazing what 1 or 2 ohms can do at this level. The LM317 works by a sort of "feedback" mechanism and when you increase the resistance in the feedback circuit, you allow more current to flow through the LM317, and if your resistor value is too high, you can burn out an led in a New York minute...


Reply
Page 2 / 2
Share: