LED String Light Qu...
 
Notifications
Clear all

LED String Light Question

16 Posts
10 Users
0 Reactions
9,835 Views
Posts: 24
(@speeddy)
Eminent Member
Joined: 18 years ago

big lots has pretty good deal 13.50 for 120 m5 leds they come two strings to a box .Last year I got them 3.19 box cleaned them out


Reply
TomsLEDs
Posts: 444
(@tomsleds)
Honorable Member
Joined: 7 years ago

I have a few commercial LED strands that have 3 color rotary switch selectors for chasing or single color modes. I use them in wire frame spiral trees. Could I unsolder the factory controller and set them up on my e682 fairly easy?


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

You will need to give us a bit more information. Do you have model number? Manufacturer? A picture of the wires coming out of the controller and a short video of the lights in action? The description you gave does not sound like a pixel but we would have to have more data to help you out.


Reply
TomsLEDs
Posts: 444
(@tomsleds)
Honorable Member
Joined: 7 years ago

Okay, I will have to get them out when I get home. One tree was red, one was blue and the 3rd was green. I can't remember if I set them up that way or bought them in those colors? So if they are single color LEDs with pattern effects only, what simple controller works for that? I'm pretty sure they are addressable since you can make them chase. I know I need more controllers and possibly one or two for non-addressable single color LED.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

need a vid of thw chase, i bet it is a three or four string chase


Reply
TomsLEDs
Posts: 444
(@tomsleds)
Honorable Member
Joined: 7 years ago

Sorry it took so long to get back to this, got distracted by my 34x30 pixel matrix build. So I did crack open the controller. Funny it it has 2 wire output with one labeled +RGB, the the -RGB. Yet it can change the strand to solid red, green or blue; then fade all lights together or send a chase using a white light command. One side of the pc board is a full bridge rectifier with a huge dc smoothing capacitor. Other side there is a signal receiver dead center; also 2 program chips U1 & U2. U1 is not marked but U2 looks identical and it's a 24C02C 5.0 volt eeprom. The puzzling part is the DC bus measures 161 VDC???

Couple more things. There is a 3,600 ohm limiting resistor soldered to every 3rd LED. The pigtail label says Paradise Model U001-1422. BTW, this is a sealed clear rope light. I can see there are 2 wires that run the entire length that are just used to daisy chain the next set. I believe the combined load of all the resistors and the LEDs themselves brings the voltage down to a useable level. They are 18' long with about 9 LEDs per foot. Here is a link to a listing for them although I bought mine at Costco. https://www.amazon.com/Paradise-Rope-Light-Indoor-Outdoor/dp/B07ZT33L81

My guess is there is a small addressable chip in the LED, but I don't think it could addressed by a standard controller as nothing I've seen out there can handle that much DC voltage. I have an old Mr Christmas light controller with an analog ac relay panel I can modify to at least turn them on on of,f but I wont be able to set the colors.


Reply
Page 2 / 2
Share: