I need to finish assembling my fast snow fall items. Asking those with experience, what's the usual number of segments, 2 or 3 for a snow fall tube?
I'm guessing my segments are shorter; assembled length is about 4 feet.
I have 4ft and 2ft.
Skunberg, do you have video of your show. I am planning to add FAST tubes this year and ordered kits to make 20 x 2ft tubes. Maybe I should consider putting in some 4 ft tubes as well. Let me know your thoughts and if you have video that would be very helpful. They will all be going on my single large tree in the front of my house.
Thanks
I did just 2 segments, 10 tubes, along the gutter line of my garage/sidewalk. I varied the programming of the PIC chips so no two started or fell at the same place/same rate. If my house was farther away from the street I might have considered 3 segments, but being only 20-25 ft I went with 2.
mharnish wrote:Skunberg, do you have video of your show. I am planning to add FAST tubes this year and ordered kits to make 20 x 2ft tubes. Maybe I should consider putting in some 4 ft tubes as well. Let me know your thoughts and if you have video that would be very helpful. They will all be going on my single large tree in the front of my house.Thanks
I'll put up a link when I get home. I have them on my roofline about 2ft apart alternating 4ft, 2ft. I wish I had all 4ft. But it's subjective like a megatree.
I have about 50 of them hanging in the trees spread out over 100ft, a mix of 2ft and 4ft. Some are blue and most are white. I like the longer ones simply because it is not something you can buy in the store, so it stands out. The snowfall tubes do get mentioned frequently by people.
Thanks I appreciate all the replies. I'll have to decide on if I should place another order. I'm currently putting 3 segments in a tube which will give me a dozen snow fall's.
One more thing, are you using 2 conductor water proof pig tails for the supply wires?
How are you sealing the wire entry way thru the tube cap?
Only thing I can come up with is silicone sealant to do that with.
I'm using a 4 pin connector smaller than the whites you see everyone using. I run them over the top of the tube and slide the black cap over it. And don't seal it at all.
I haven't bought any tubes yet to actually put a cap on to see what you are describing. The caps must be flexible enough to be able to stretch over your cable. Do you mind saying where you find a smaller diameter 4 conductor water proof pig tail cable?
