FAST construction q...
 
Notifications
Clear all

FAST construction question

7 Posts
6 Users
0 Reactions
2,083 Views
Posts: 528
Topic starter
(@bud29)
Honorable Member
Joined: 17 years ago
[#22971]

Well, after a year of putting it off and avoiding them, I have finally finished soldering all my FAST lights together. I bought the black hanger thingys that DIYledexpress was selling, and have some flourescent tube protectors to put the FASTs in. My question is, how did anyone enter the cable into the FAST tube to avoid water entry? Did you go in through the top and silicone around it, or come in from the bottom or?

Pictures would be a bonus if anyones got them. I've just spent so much time building these bloody things, I don't want to see them ruined by moisture entry.

Thanks,

Rob


6 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Neither - - I used a Cat5 pair (I stripped out about 3' of pairs from a cable) and used that to run up under the top and back down to the board. Water can't really get in up the tiny gap. These use very little power (~25mA) so it's more than hefty enough but it's not exactly the strongest connection so I tie it around the loop at top to provide some measure of relief from the occasional yank/pull... I then ran the 4 pairs back to a Ren48LSD and that was it. You can put many more on a channel but I had plenty of LSD's around...


Reply
Posts: 1744
(@tjetzer)
Noble Member
Joined: 18 years ago

I poked a tiny hole in the top cap and ran 2 Cat5 strands in. I then sealed it with a dab of hot glue.


Reply
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

I did what budude did too


Reply
Posts: 528
Topic starter
(@bud29)
Honorable Member
Joined: 17 years ago

Thanks guys, I was thinking cat 5 wires should be good enough. Soldering all these things was enough to drive me to drink on more than one night, sure don't wanna see them get wet.

Thanks again,

Rob


Reply
Posts: 555
(@zaker)
Honorable Member
Joined: 19 years ago

I did a hole in top and a dab of silicone. Something my son did also, he got the heat gun and got the tube, then twisted it in one direction, then the other down the length of the tube. Makes it look like is more of an icicle than a plastic tube. Also my wife does not like all white, so mine are white/blue alternating. Looks different.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

I think poking a hole in the top is the 2nd option to budude's suggestion. I asked the same question a couple weeks ago and I was probably Brian who answered with this method. It was a "Duh!" moment for me. Very simple and works great.

I'm with you on the soldering. Soldering 1100 Leds drove me nuts.


Reply
Share: