Cheap LED Strings
 
Notifications
Clear all

Cheap LED Strings

76 Posts
18 Users
0 Reactions
38.8 K Views
Posts: 255
(@frankv)
Reputable Member
Joined: 17 years ago
SteveXmas wrote:The problem is the individual wires are incredibly cheap, and smaller than the smallest gauge on my wire stripper.

Use a soldering iron to melt the plastic insulation off the wires.

This is bad for the soldering iron tip, and quite smelly, so I suggest you sneak into your enemy's house and use his soldering iron. Probably the smoke is carcenogenic, so ideally talk your enemy into doing it for you.


Reply
Posts: 255
(@frankv)
Reputable Member
Joined: 17 years ago
dirknerkle wrote:Try a Kill-a-Watt meter on them. I'll bet they're way down next to nothing.

Given the thinness of the wires, the current has got to be tiny.


Reply
Posts: 11
(@stevexmas)
Active Member
Joined: 16 years ago

I ended up using a razor blade and a microscope to strip the wires, and it took several tries (the strings are a little shorter now 🙂 ). I won't be buying any more of these lights...


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago
SteveXmas wrote:I ended up using a razor blade and a microscope to strip the wires, and it took several tries (the strings are a little shorter now 🙂 ).

A trick that a few of us Techs (that have been around the sun a few more times) use, is to use a small diagonal cutter and squeeze only enough to bite through the insulation and then pull. Kind of an American/Metric one-size-fits-all method. Most of the time it works and sometimes it splits the insulation and you just cut it off.


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

And other times it pulls the thin wire straight out of the insulation... 😉

I've purchased a mega-tree qty of these recently at around $6 a throw. I've come up with a technique to remove the control box, and wire up an inline bridge using the diodes out of the control box. you end up with a small heat shrink lump in the wire near the plug. Full wave and reasonably inexpensive (not counting time). The only thing is that if you think the wires and control box are cheaply made, you need to look at the plug end to really see cheap manufacturing. I've been mostly replacing the cord ends with the leftovers from chopping multitap heads off cheap extensions cords to use the multitaps as controller outputs.

I have pictures if anyone wants a writeup.


Reply
Page 13 / 16
Share: