I purchased some 60/meter 5050 RGB LED strips and theyseem to stiff to bend. I want to cut the roll into 1 meter (or smaller) strips for my display and curve each section into a semi-circle but the strips are so thick with the waterproofing and flat strip that I can not bend. It is flexible to roll, but not bend. Anyone have any success? I've thiought about trying to heat and bend? I really don't want to cut at each3-LED point to solderin a short length of wire.
Those LED strips aren't meant to bend along that axis and I'm pretty certain that any attempt to do so will damage it. I have seen some LED strips that have side directional SMD's in them. They bend in the same way as normal strips but since the LED's shine out the side, it would bend how you want them to (with the lights facing out). They're also a bit more expensive than normal strips. Obviously this is no help for what you already bought but I'm sure there are ways to get around your issue. This is a DIY site after all. :wink2:
One thing you might be able to do is to "mount" them into some white (its translucent) Pex tubing. The LED strip will make the tubing glow all the way around so it might work for what you are trying to do. I put the word mount in quotes because you really just slide them into the tubing. If you want to use multiple segments you would need a large enough diameter to fit your wires in there as well. I was thinking of using this method to build some RGB arches. Home Depot and Lowes sells Pex in various diameters and its relatively inexpensive. For instance, a 3/4" 50 foot roll is under $30.
I'm sure someone on here will have a way to make these work for you. Good luck and be sure to let us know what you end up doing (with pictures of course).
If you're trying to bend them with a sharp corner at the cut point (or at any point in the strip), you will likely sever the traces. I have taken the heat shrink tube off the end to solder my own connectors to my strips and noticed some of them have broken traces at what looked like bend marks--probably due to mishandling at the factory. The traces on the strips are susceptible to breakage due to bending so I would advise against it.
