Ok, so I have read the post on the difference between WS2811 and WS2812. I have also discovered the difference myself, when I got my firs strip working. I must not have fully understood, because I now see the 3 led per chip, actually all light up the same color, instead of each pixel. But now I am a bit lost. Do WS2811 pixel strings ALSO work in 3's? Or do I need WS2812 strings?
Sent from my SM-G950U using Tapatalk
Leds per pixel is a strip design . String pixels can be grouped via your controller settings to some what replicate 3 leds per pixel .
Pixel ratings on strip can be a little confusing if the fine print is not specified.
A common configuration of strip is 10 pixel ic's per meter or 30 leds per meter .
This strip is 3x rgb leds per ic which creates a broad pixel compared to single rgb led pixels .
Pixel strings (bullets and nodes) are all individual unless you buy a dumb string which changes every pixel in the string the same color. Pixel strips are individual in the WS2812 package since the chip and the LEDs are all in one package mounted on the flexible circuit board. However, it is possible to get pixel strips using the WS2811 chip that controls 1 or more LEDs at a time, although groups of 3 are the most common. You have to read the descriptions carefully. Usually, you will see something like 30/10 which indicates 30 LEDs per meter but only 10 pixels (or 3 LEDs per chip). Hopefully, this makes sense to you.
ezellner wrote:Pixel strings (bullets and nodes) are all individual unless you buy a dumb string which changes every pixel in the string the same color. Pixel strips are individual in the WS2812 package since the chip and the LEDs are all in one package mounted on the flexible circuit board. However, it is possible to get pixel strips using the WS2811 chip that controls 1 or more LEDs at a time, although groups of 3 are the most common. You have to read the descriptions carefully. Usually, you will see something like 30/10 which indicates 30 LEDs per meter but only 10 pixels (or 3 LEDs per chip). Hopefully, this makes sense to you.
Yeah, it does. I now understand that with pixel STRIPS there can be many ways of configurring them, but with pixel STRINGS the LEDs are controlled individually, unless they are dumb sttings. Thanks!
Sent from my SM-G950U using Tapatalk
