12V toleration node...
 
Notifications
Clear all

12V toleration node pixels

5 Posts
4 Users
0 Reactions
2,238 Views
Posts: 29
Topic starter
(@aumoenoav)
Eminent Member
Joined: 9 years ago
[#46249]

When trying to figure out when to do power injection, is it any "rule of thumb" of how low can the voltage drop on node pixels before it will be visible and need a power injection?


4 Replies
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

It depends. If you run 100% intensity white, you'll need to inject every 100 pixels. If you power at 50% you can inject less often but it also depends on how long your wire runs are and the size of wire you are using. There's enough difference in strings and setup you probably need to try it out yourself and see where you end up with voltage before there are issues. I'm sure others will have some good input.


Reply
Posts: 29
Topic starter
(@aumoenoav)
Eminent Member
Joined: 9 years ago
ezellner wrote:It depends. If you run 100% intensity white, you'll need to inject every 100 pixels. If you power at 50% you can inject less often but it also depends on how long your wire runs are and the size of wire you are using. There's enough difference in strings and setup you probably need to try it out yourself and see where you end up with voltage before there are issues. I'm sure others will have some good input.

But how much voltage does it need to run in full intensity before it start to look dimmer? I guess you can pass a bit below 12V before it start to affect the pixels?


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

What happens with pixels is as the voltage drop becomes significant Full White becomes pinkish towards the end of the run. When you see that happen, you know you need to do a power injection.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

On my 12v test strings, I get pink at 9v. But that does not mean yours will do the same thing.


Reply
Share: