amrutherford2012 wrote:Is that jig 3D printed? If you are asking me; yes I used a 3d printed jig last year
Nothing new, just it started to snow so a bit more christmasy hehe.
jmruth72 wrote:Hello, So I am not sure exactly what is getting warm. Is it the connectors or the cable? If it is the cable is the whole cable or just ...
Yes, maybe. I measured it now, and it refuse to draw more than 3 amps (and still burning warm), so I guess its bad plugs. Maybe using wago is a bette...
I tried the firmware on a NodeMCU, and it works with no issues (just cause of testing, dont have any official controllers on hand right now), but is i...
ezellner wrote:It depends. If you run 100% intensity white, you'll need to inject every 100 pixels. If you power at 50% you can inject less often but ...
MrDudeMan wrote:i disagree about "because of house style"... you have a lot you can work with.. 3 tree's 4 windows 1 door... the railing on the stair...
MrDudeMan wrote:american living in norway here.. ive installed the lights at 2 other places in norway and both places the neighbors complained. final...
I think I might have figured it out by using and a RF reciever I can use to start a sequence. Lets hope it will work
