Thanks for the replies.
Yes I do want to be able to control the 4 strings separately. I have a few of these strings and being able to have all the lights in my show in one color than another should look good.
I will go out to the shed in a little while and snap some pics of the string of LEDs but I ditched the boxes last year when I got them.
You where asking about the packaging yes?
I hope these pics are alright. The string is log enough to go around the front of my house, down one side and around my double shed. Hope this all helps.
Josh
The lack of a resistor would indicate Pulse Width Modulation is being used and the supplier is using the Transformer current limit and has adjusted the ON time to limit the current to a "safe" limit.
So my guess is you won't want to connect them directly to a DC source without measuring a few things.
With a bit more information we might be able to help out.
Are all the LEDs grouped by Colour? ie Do all the red LEDs light up together?
How many LEDs per string ( connected in series)?
Cheers
Matt
Try this.
Remove the Led light string from the controller. You could use a small bridge rectifier but if it is easier for you to reuse the controller board I have shown a pic of where to solder wires onto 2 of the diodes, for power to the SSR. You can remove unused components form the board if you like (just leave the 4 diodes). Then connect it up as per 2nd pic.
Craig.
prof wrote:Try this.Remove the Led light string from the controller. You could use a small bridge rectifier but if it is easier for you to reuse the controller board I have shown a pic of where to solder wires onto 2 of the diodes, for power to the SSR. You can remove unused components form the board if you like (just leave the 4 diodes). Then connect it up as per 2nd pic.
Craig.
Hadn't thought of that. Unfiltered full wave rectification returns to 0v just like the AC stuff. Neat!
Thanks for the replies guys.
I really wish I could try this out but.....I am having a real problem getting my 595's working (see 595 thread).
Just a stupid question...In the interest of neatness would there be any issue removing the components from the board and re-working them on a bread board so long as they stay in the same sequence?
Josh
