How do I remove 8 f...
 
Notifications
Clear all

How do I remove 8 function controller from light string?

61 Posts
19 Users
0 Reactions
51.8 K Views
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 19 years ago

Changing controller speed

It is also possible to change the speed of the controller. It changes the speed of all of the 8 functions. Can be handy for some special effects.

Inspect the circuit closely. You will discover one resistor that purely connects one IC pin to another IC pin. That is the timing resistor. Reduce its value to speed up the controller. Increase it to slow it down. Or change it to a variable resistor so you can alter it at will.
this may or maynot work on newer controllers...
read more here http://computerchristmas.com/christmas/link-how_to/HowToId-23/Make_an_8-function_controller_remember_the_setting


Reply
piesrule58
Posts: 443
Topic starter
(@piesrule58)
Honorable Member
Joined: 19 years ago

How do I remove 8 function controller from LED string?

Hi,

I have some 16pc LED Fibre Optic Light strings (Pictures attached) I want to remove or modify the 8 function controller so it becomes a simple on - off set. I believe it is a bit more complicated than mini light sets because of the resistors etc. They run off a 24v wall wart. Any help would be appreciated.

Thanks, Terry

led's 002
led's 004

Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

Re: How do I remove 8 function controller from LED string?

Any chance of a slightly clearer photo?


Reply
prof
Posts: 266
 prof
(@prof)
Reputable Member
Joined: 19 years ago

Re: How do I remove 8 function controller from LED string?

What controller/ssr combination are you planning on using to control the leds ?

Can you post a picture of the underside of the board as sometimes there can be components/links mounted there.

I have done what you want to some different sets of led lights that use that basic controller so I will be able to help.

Craig.


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

Re: How do I remove 8 function controller from LED string?

Hi.. Ok, i tryed to figure it out, but i can't figure out the values..

Theres 3 'channels' in that controller.. Is there four wires going out to the leds? One will be a common ( probably tied to ground, although not entirely guarrenteed )....

each channel will need a resistor in series with it...


Reply
Page 2 / 13
Share: