Hi Joe...just upgraded to new version but the few sequences...about 6 of them....no longer open. I only open them now if I open sequence it fails to open then I hit cancel and the folders come up and then I select it manually. Then it opens. The question is do I have to manually open them from now on
I just recompiled 13V and reposted it.
Download 13V again and see.
Nothing changed so it may have been a bad compile.
As another solution - just blow away the saved list and start it over again.
In your HLS folder is the file "HLS_ActiveFileList1.txt".
Delete that file - then when you go to open a sequence - the list will be empty --- manually select - from there on it should remember.
That's about all I can offer at this time.
Joe
Open your sequence as you normally would as in Fig.1
Highlight your file as in Gig.2
Click Remove as in Fig.3
Click cancel and this will take you to your HLS folder where you can select your file manually as in Fig.4
This will replace the file name under "Open HLS Sequence" at the start.
Do this with all of your sequences and they will be opened normally in future.
Hope this helps as I'm not very good at writing instructions.
That worked. Basically open the file list .....remove sequence.... then cancel ....then manualy open it..... then after you close it , it opened normal.....Thanks




