Hi Joe, sorry to be a pain, but i am getting around preview ok now, However?
How do i enter custom elements?
I can draw and associate pixels to each selected box (pink to green colouring- eg candy cane shape)
How do i actually tell in preview setup, what lights to align to the custom element i have drawn.
As i cant seem to access any further other than custom object design window and then the preview toolbar window (13M version being used at the moment). again any help greatly appreciated
cheers Boof63:mellow:
Left Click on the Name of the Custom Effect
Right Click on Cell to assign Pixel to --- it a one-by-one pixel assignment
OR --- What I do --- click "Switch Mode" and then enter the Group-Channel by hand - per cell
You only fill in the cells you want --- so if you have a candy cane --- draw your candy cane by assigning pixels to specific cells.
The example above is from a DIY Member that was testing Custom as a complete PixelPlane --- so he assigned all cells.
Joe
ok thank you joe AGAIN!!!!, now i have worked that out, in Raw channels- the preview channel allocated to each element is then entered against each pixel of the corresponding custom element. thank you heaps for your patience/ IBelieve i'm now on my way for the 2013 show.
cheers Boof63
In Raw Channels --- each channel is identified by a Universe/Channel combination (columns 2 and 3 of the grid) ----- Slide and look at the far right-hand side of the grid --- you will find Preview Group/Channel combination.
It's the Preview Group/Channel that is used in the Preview channel association. Please also note ... Preview Groups are NOT the same as DMX Universes so ---- you can use a single group of 5000 channels for example to map to a single Preview display item - like a MegaTree.
Joe
I'm confused. I needed to draw pixels around my windows so I though I would use custom since its easier than drawing nice straight lines plus I could better control the x and Y pixel counts. Needless to say things didn't come out the way I expected.
What did I try? I drew a custom box around the outside of a window and then started assigning pixels. When the grid popped up I noticed it had a whole lot more cells that I would need so I assigned channels in the cells, upper left justified, I needed for each side of the box, in my case 19 high and 6 wide. When I was finished I noticed was that only a small part of the original box was used so the pixels were not running around the window but just in a corner of the window. Not exactly what I had in mind. I guess though that since I didn't have anyway to set the grid X & Y values justifying the outer most pixels I used to the outer edges of the box seemed reasonable.
So how can we go about having the custom elements sizes and the number of pixels all match up? For dumb strings it's not a problem but when doing pixels we need placement control that's reasonable close.
My suggestion would be to justify the outer most limits of the assigned pixels to the outer edges of the box that was drawn or let us change the X & Y counts. If the image is a bit skewed so be it since that's likely going to be due to viewed perspective.
If I'm missing something or if there is a better way to do this will someone please enlighten me.



