hello i have just bought a grinch from a DIYC member and it came with a ren-c i am new to this type of controller i understand i need a ren t to power it is there anyone who can help me obtain one or even biuld one were can i find the pcb and BOM another thing what type of ssrs do i need i do want to be able to dim channels
a ren-c + grinch does NOT need a ren-t to power it.
you need to power the grinch with a 5v DC 1 amp (ish) power source.
also required is a ZC signal for the ren-c. this can be a small center tap transformer with 2 diodes or a normal transformer with a h11aa1 opto and a couple of resistors.
i prefer the opto method but its just personal prefernce. also required is a serial cable from the ren-c to the pc. this only need to be 2 wires. same as the standard renard serial cable.
Check the wiki for specific information about the different options.
Regards
Peter
The Ren T will provide the zero cross signal, if that's the route you want to take. There are other methods to provide the zero cross as well.
