multi ren-c
 
Notifications
Clear all

multi ren-c

22 Posts
7 Users
0 Reactions
15.4 K Views
Posts: 93
Topic starter
(@quefol)
Estimable Member
Joined: 18 years ago
[#16898]

im having a problem connecting two ren-c's iv got one connected to a olsen and one to a grinch the ren-c on the olsen is daisy chained to the ren-c on the grinch when i try to run it as a single controller the grinch doent what to work it has power the ren-c and is getting data from the ren-t this i know because the data led flashes on the ren-c do i need to change the braud rate it is set at 57600 or dose the ren-c need some type of addressing


21 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Both Ren-C's need to have the ZC signal -- is the 2nd Ren-C blinking it's ZC LED???


Reply
Posts: 93
Topic starter
(@quefol)
Estimable Member
Joined: 18 years ago

yes it does


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Can I ask a question in this thread that pertains to multiple RenC's? Good. LOL
Does the data cable pass ZC to the 2nd or 3rd Ren or do you have to go the jumper route?

In answer to your question; I have yet to try my two grinches connected with my Ren-Cs, but I may try in the next day or so. Maybe I can shed some light on the topic if things happen.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

The ZC has to be supplied to the Ren-C individually, not through the cat5 connection. Also, the PIC on the Ren-C must be set at the same baud rate that your Vixen plugin is set to. I'd try 57600, No parity, 8 data bits, 1 stop bit as a starter. If that doesn't work, try dropping down to the next lower speed, then lower, etc. If it never connects, then you'll have to do a little more digging because it's very difficult to know whether the problem is:

(a) your data cable
(b) the baud rate of the Ren-C's PIC16F627A chip
(c) whether the Grinch is actually working

Do one thing at a time. The only way I know how to test the Grinch is to bypass the Ren-C completely and hook it up natively to a parallel port with the proper cabling and test each channel.

If it tests out, then work backwards and make sure your cables between the Grinch and the Ren-C are relatively short (< 12" or so), that you have the proper serial cable (a very common problem), and that the ZC LED is blinking about once/second.

After that, you might have to reflash the 16F627A chip's firmware with known-baud rate settings, and try it again. All this is assuming that your PC's serial port is working and that the Vixen plug-in is set properly, too...


Reply
Page 1 / 5
Share: