dirknerkle wrote:The ZC has to be supplied to the Ren-C individually, not through the cat5 connection.
My ZC runs through the cat 5. My setup goes from the serial port to REN-T to REN-C #1 to REN-C #2 to REN-C #3. I have 595's connected to the REN-C's and each of those have seperate DC power feeds.
Dan Ross wrote:My ZC runs through the cat 5. My setup goes from the serial port to REN-T to REN-C #1 to REN-C #2 to REN-C #3. I have 595's connected to the REN-C's and each of those have seperate DC power feeds.
Excellent -- I stand corrected -- but I believe that only applies if you're using a Ren-T or if you've spliced your input cable to include ZC from an alternate source. I don't believe it goes through if you connect ZC to the header pins along the bottom left of the Ren-C board... but... I've been wrong before (lots and lots of times) and I could be blowin' smoke here, too...
reply to the original post looks like i found the problem turns out i had a crossed wire on the return cable from
the grinch to the ren-c thanks dirknerkle
Good deal! It's great that you posted the solution to the problem because that can help others!
If I were to guess as the #1 problem that DIY'ers encounter with this hobby, it's making cables. That single issue accounts for more confusion than any other.
Don't know why but grinches ren c's I'm starting to hate. I had all three grinches working with parallel port, no problem. All three ren c's work individually with single grinch(one at a time of course). Try to add a second ren c grinch then no heartbeat. I still have 5 volts on grinch. Any help would be appreicated. Grinches are powered individually.
