Testing using test ...
 
Notifications
Clear all

Testing using test tab xlights

14 Posts
7 Users
0 Reactions
5,523 Views
Posts: 32
Topic starter
(@paladin)
Eminent Member
Joined: 12 years ago

Thank you for that information. My manual doesn't even talk about the test pattern. That was the default when I built the board and powered it on for the first time. Subsequently I've changed that test pattern to 0, which in turned all the lights off, but now they aren't even cycling through as before. I'm still not getting a test out of XLights. Changing the test pattern value turns on different colors at least on mine it does.


Reply
Posts: 32
Topic starter
(@paladin)
Eminent Member
Joined: 12 years ago

Yes the difference between multicast and unicast is the number of universes that will work or can be set up. The manual was pretty specific about that point. I changed mine to unicast and put in my controllers address and still nothing. As previously stated I changed the test pattern to 0. Now I guess back to square one where I started at. Nothing out of xlights, and the built in test pattern is not working at this time.


Reply
Posts: 32
Topic starter
(@paladin)
Eminent Member
Joined: 12 years ago

Update, I went back and changed back to multicast. Then I went back to the test page. This is where I got confused at. So earlier when I was trying there are 3 tabs, standard, RGB, and RGB cycle. Because I was working with RGB pixels, I selected the RGB. This time I went back and changed and used the standard. At this time the first string went through the test cycle just as described in the manual. At least from what I remember. They actually started out blue, then red and finally green. Not exactly RGB, but the colors are there. Only problem now is the first strip will test, and then that is it. Nothing on the second strip. But that may be a setup problem in my definition of how many pixels.


Reply
Posts: 91
(@dennismc)
Estimable Member
Joined: 13 years ago

You have the IP address of the 682 set to a "link local" IP: 169.254.74.73 (default for SANDevices). You should set it to an IP in the 73.XX.XX.XX range so that it is on your network. It would be a good idea to configure your router so it "knows" what the IP and MAC address is -- most routers have a spot to configure "fixed IP addresses" in the DHCP tab.

Regards,

The Dennis


Reply
Page 3 / 3
Share: