Show FPS settings
 
Notifications
Clear all

Show FPS settings

5 Posts
4 Users
1 Reactions
986 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
[#58383]

A lot of the discussion on this forum seems to revolve around either 20 or 40 fps for sequencing and show display. Where did those values originate? And do people often use frame rates other than those two?


4 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I think it was originally derived via mathematics. 1000 milliseconds are easily divisible by both 20 and 40, making it easier using 8-bit chips because of their generally spartan available math functions.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 19 years ago
dirknerkle wrote:
I think it was originally derived via mathematics. 1000 milliseconds are easily divisible by both 20 and 40, making it easier using 8-bit chips because of their generally spartan available math functions.

I suspect that there is something more to the story, as 1000 mS is also easily divisible by 25 and 50, allowing 40 mS and 20 mS periods instead of 50 mS and 25 mS.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I suspect it is partly driven by our eyes. The 20FPS is a bit slow for our eyes (Film is at 30 FPS and now higher). I know that 20FPS does not have smooth transitions. I also remember reading that using 30 FPS caused problems with cameras and that drove a change to 40 FPS (faster than the common camera but slow by todays standard.

Again, this is just 2nd and third hand observations.


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

The main reason originally was due to DMX and PixelNet. A full universe of 512 channels takes about 21ms to output over a normal DMX 250 kbps connection. Thus, the next "easily divisible" value that can output a full universe is 25ms, or 40fps.

PixelNet, which was somewhat popular at the time, also used RJ45 serial connections, but it was 4096 channels at 1Mbps connection. That would take roughly 42ms to transmit. Thus, pixel net users were really stuck with 20fps.

Anyway, that's a bit of ancient history. PixelNet is not likely used by anyone anymore and I'm not sure if anyone is sending full DMX universes anywhere anymore either. People tend to just have a few LOR controllers or a couple moving heads now which wouldn't require the full 512 channels.


Reply
Share: