i pocked up a pic programmer a few months back from e bay and now have gotten the time to look at the thing, i dont know how to use it, but i need to learn, could one of you help me, get the correct software? it is the and the computer that the software that it will be on, for pic programming, is not connect, and will not be connected to the internet any time soon.
There are lots if K150 USB Automatic ICPS kits available on ebay for around $10 bucks. The PIC16F688 on my renard is listed as compatible. Has anyone had any experience with this kind of PIC programmer? What software would it use?
andyhough wrote:There are lots if K150 USB Automatic ICPS kits available on ebay for around $10 bucks. The PIC16F688 on my renard is listed as compatible. Has anyone had any experience with this kind of PIC programmer?
Yes, I picked one up from Amazon. It was absolute garbage. No software. No instructions. The USB cable was off-spec and barely fit in my USB port. The firmware (which was several years old) didn't match the software they recommended. I tried with the old, correct software and while it would read and clear my PIC16F688s, it failed on the update and left them in a useless state. The only way to update the programmer firmware is to purchase a new chip and flash it with the old software, then install the new chip and upgrade the software to match the firmware. It was a nightmare.
I sent it back and ordered a iCA03 on eBay for $33.80 including shipping from Malaysia. It should be here in the next few days. DIYLEDExpress is selling them on their pre-sale for the same amount - http://www.diyledexpress.com/index.php?main_page=product_info&cPath=32&products_id=194 - if you're willing to wait until ~May to get it.
The iCA03 is a great and inexpensive programmer for what we do here. I held a GB on them a couple years ago, so there a lot of members here using them and I have not read of any issues with them.
