IP address help.
 
Notifications
Clear all

IP address help.

7 Posts
5 Users
0 Reactions
3,394 Views
Posts: 46
Topic starter
(@dcall)
Trusted Member
Joined: 11 years ago
[#39390]

Well its not been easy but with the help given here and reading old posts I did it! almost....:rolleyes:
I have managed to solder my E628 card and show a test pattern.
I set-up Vixen3 with an RGB arch "test item" this worked on the preview screen.
Eventually I got my test pattern it to work using a string of WS2011s. whooooo
But this is the problem. I have to use option 4 and force an IP onto the E628.
I Know the ip address setting look easy but its got me frustrated.
I use my laptop off line when running my lights and have the E628 card wired directly.
When I want to use the internet I plug my laptop back into my wired network.
I dont know if this would affect the IP address (changing it each time)
This is the only card I have, so I don’t think I need to get fancy adding a network switch
I only plan on using 200 leds and a strip of neopixels this year.
So if I had an ipv4 169.254.25.25 1 what would be the best number to give the E628?
I thought just altering the last number would do the trick but it wouldn’t reconnect.
Any help getting me to understand my IP address would be great.
Dale


6 Replies
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

You need to make sure that the IP you give your controller doesn't match another device on your network. All you have to do is change the last number. 169.254.25.xxx. How are you hooked up to the internet now? A switch isn't fancy and/or expensive, but it can save you a lot of trouble. You can get a switch on Amazon for about $10-20.

After re-reading your post. You are using a laptop. I am assuming it has wireless. Use the wireless to connect to the internet and the wired ethernet port to connect to the 682. No worries. Do you have wireless?


Reply
Posts: 555
(@zaker)
Honorable Member
Joined: 19 years ago

The default IP of the e682 is 192.168.1.206, if you go into the IPv4 settings of your laptop and go to the alternate tab, set the IP for 192.168.1.200. They will both be on the same subnet, and most likely those IPs aren't used on your network, most use lower address if in the 192.168 range. Laptop and e682 will communicate.

When you go to your wired network, it will get an IP from your router and work as normal.

The 169.254.x.x is an APIPA address, if nothing on your network has DHCP server (assigns IP address on the network) the windows devices will use this range so they can communicate with each other.


Reply
Posts: 46
Topic starter
(@dcall)
Trusted Member
Joined: 11 years ago

Thank you both now it sounds simple..
I was confusing myself with all the numbers
led numbers , rgb x3, string numbers, controller number, universe number ahaaaaaa
I dont use the wireless connection to the laptop I was just swapping the cables over.
But a switch might be the way to go
Cheers Dale


Reply
Posts: 99
(@mazobob)
Estimable Member
Joined: 13 years ago

If you are hooking a network cable directly between the 2 devices, you will need a crossover cable.


Reply
Page 1 / 2
Share: