IP address help.
 
Notifications
Clear all

IP address help.

7 Posts
5 Users
0 Reactions
3,395 Views
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

FYI, your 169.254.x.x address indicates a problem networking. The 169 block is an automatic private IP address(APIPA). When your NIC can't contact a DHCP server and is told to be in automatic (DHCP) mode, it randomly picks an IP from this block.

In normal operations, you shouldn't ever have a 169.254.x.x IP. You need to provide a manual IP on your NIC or have it able to contact a DHCP server (usually provided by your WAP or ISP).

The reason it got that IP is when you wired your laptop directly to your light controller. Your laptop may have an automatic crossover LAN port. If it does, then this will work but isn't the best choice. If it doesn't have auto-crossover ability then you wont ever connect to the lighting controller using a standard network cable. This will require a special crossover cable.

However, to be honest, switches are damn cheap. They require no configuring, no set up. Just plug them in and they do what they are supposed to do. IMHO, you would be far better hooking up a switch and then run from the switch to your lighting controller and from the switch to the laptop. This would allow the laptop to remain connected to your network and thus the internet with no changes needed there. You simply configure the lighting controller to be on the same IP block as your laptop. Then you are done. No more screwing around swapping cables.

[Internet] (ISP assigned IP)
|
|
|
v
[SWITCH]
1 2 3 4
| | | |
| | | |--------[Future]
| | | ---------[Future]
| ------------[E682] = Lights 192.168.1.206
|
|
|---------[Laptop] (ISP assigned IP) + 192.168.1.200

As you can see, hookup is very simple and once done, its done for the future. Get a 4 port switch (or 8). That gives you 1 for the laptop and 3 for other things, one of which is your E682 leaving you with 2 more for later. As mentioned above go into the properties on your NIC and add a 192.168.1.200 IP address to it under advanced. Don't worry, that IP traffic can travel over the same network cable as that from your LAN from your ISP.

I would recommend that as soon as you establish a connection to the E682 that you change its IP to 192.168.1.201. That way when you buy another one, this current one won't be on the same IP. Then you can connect to the new one on .206 and change it to 192.168.1.202, etc.


Reply
Posts: 46
Topic starter
(@dcall)
Trusted Member
Joined: 11 years ago

Thanks for this really useful Information I thought I was going mad (well dafter).
It looks like I dont need a gross over cable as I did connect to the controller.
BUT the switch as everyone points out as by far the best solution
I have sent off for a switch at £5 free P&P. Aprox $7.5
Again thanks for your time and detailed explanation.
Dale.


Reply
Page 2 / 2
Share: