Glediator directly ...
 
Notifications
Clear all

Glediator directly output e1.31

9 Posts
6 Users
0 Reactions
5,176 Views
cbell
Posts: 462
Topic starter
(@cbell)
Honorable Member
Joined: 18 years ago
[#32058]

I keep reading that Glediator should be able to output directly to e1.31 but haven't seen a way to do it. It appears to output Artnet and I didn't know if Artnet was similar enough to e1.31 that it could be configured to work. Is anyone doing this and if so do you have any details on setting it up?


8 Replies
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

I talked to Rene (author of gladiator in Germany), he said he was thinking of adding e1.31 if enough people wanted it. As of now the only was to get e1.31 is to record a gladiator sequence and then import it into xlights


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Is artnet supported in Xlights?


Reply
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

No. Pitts plan on offering it from his falcon-16 v2 board. Could ask capt Murdoch if they will add it to the fpp. I don't think there has been a large demand for it


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I'm sorry, I'm not asking for Artnet. I thought gladiator output Artnet only and you mention in this thread import into Xlights. So I must be missing a few steps.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

The E68x pixel controllers support Art-net - this is where you need the support since you looking for a receiver, not a sender - at least going from your OP.


Reply
cbell
Posts: 462
Topic starter
(@cbell)
Honorable Member
Joined: 18 years ago

I was trying to control a komby sandwich, which afik only supports e1.31, with glediator

Sent from my Xoom Wifi using Tapatalk


Reply
Posts: 843
(@captainmurdoch)
Prominent Member
Joined: 14 years ago

FPP does not currently support Art-Net although I have considered looking at working on it sometime and have downloaded the specs so I can take a look.


Reply
Posts: 70
(@peterw)
Estimable Member
Joined: 13 years ago
cbell wrote:I keep reading that Glediator should be able to output directly to e1.31 but haven't seen a way to do it.

Take a look at Jinx! at http://www.live-leds.de/ . Jinx! looks like a clone of Glediator and it outputs to e1.31. Mapping the pixels was difficult, but it works once it is setup.


Reply
Share: