e1.31 bogging down ...
 
Notifications
Clear all

e1.31 bogging down wireless

38 Posts
12 Users
0 Reactions
15 K Views
Posts: 213
Topic starter
(@aaron1)
Estimable Member
Joined: 16 years ago
[#26426]

I'm having trouble keeping my e1.31 traffic from bogging down my wireless, so hoping someone can help me out.

My setup is this: show computer with on-board wifi and on-board GbE connections. I've also added a GbE card that I will dedicate to my e1.31 network for my pixels. I plan to use the wifi to connect to my home network. On-board GbE is unused. Wifi is assigned its IP address from my home router via DHCP. GbE card is assigned 10.10.10.2 address. All my e68x hardware is at 10.10.10.x and is running unicast.

I'm using LOR to generate the data for my pixels. I can play a sequence from LOR and get it to operate my lights just fine, so I've got everything set up correctly from that perspective.

The problem is that, when I'm driving my pixels, my wifi runs very slowly, so it seems that the pixel traffic is also being transmitted on the wifi network, in addition to the hardware connection from my PC to the controller.

I've set up a route within the Windows routing table (running Win7 64-bit) in an attempt to send all the traffic to the GbE card and keep it off the wifi connection. The command I used was:

route add 10.10.10.0 mask 255.255.255.0 10.10.10.2

Here's a screenshot of the route print command, so it appears to me like adding the route should have worked, but the wifi is still bogged down.

Clearly I'm missing something. Anyone able to help?

route print

37 Replies
Posts: 353
(@bigredsoftware)
Reputable Member
Joined: 15 years ago

Nevermind I had to change my post because I didn't read correctly. This is intriguing...


Reply
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

Just a couple of suggestions:
1.You should add a -p to make your route persistent or you will not lose it when you reboot.
2. I would disable IPv6 on both adapters to simplify things.
3. Update your network card drivers.
4. Check performance counters using task manager to see if you are getting any spikes in memory/cpu/network.

I don't have any pixels as of yet (just dumb RGB), but I run things over E1.31 with both wireless for my internet connection and my wired connection for E1.31 and I have no issues with 70DMX and 32 renard channels. Maybe someone can chime in with a pixel setup and similar setup to help rate performance?


Reply
Posts: 213
Topic starter
(@aaron1)
Estimable Member
Joined: 16 years ago

I plan to make the route permanent when I get everything figured out.

I'm not a networking guy, so forgive the following question: As for ipv6, what will I lose if I turn it off? For that matter, what do gain?

I'll follow your last two suggestions as well.

To give an idea of the amount of data... Right now, I've got about 20 universes set up; will have 31 when I have it all ready for this year.


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

You won't lose anything by dropping IP6 when your behind your Internet router.


Reply
Page 1 / 8
Share: