e1.31 bogging down ...
 
Notifications
Clear all

e1.31 bogging down wireless

38 Posts
12 Users
0 Reactions
15 K Views
Posts: 213
Topic starter
(@aaron1)
Estimable Member
Joined: 16 years ago

Woohoo! It's working!

But before I tell everyone what finally solved it, let me say Thanks to everyone for all their suggestions. Each one took me down the trouble-shooting path that finally got us there.

So, it was partially my ignorance. Partially some stupidity. And partially some bad luck.

In then end, what I realized when looking more closely at the Wireshark capture is that NOT ALL of the e1.31 data was going out on the wifi. The way LOR Comm Listener works is that, for all universes defined in the Network Configuration, it sends out updates for all universes constantly. Even when there's no data being sent to the Comm Listener from the Sequence Editor or Show Player. So, because I have my entire e1.31 network defined (the stupidity part), and because I only had one of the e682s in the network (here's the bad luck part - I removed the other controllers and the switch in order to isolate my problem), there was traffic that was trying to find hardware that wasn't connected to the e1.31 network. So, not finding those IP addresses there, Win7 was sending it out on the wifi. That was my ignorance part. I didn't realize this would be the behavior I should expect. Have I mentioned I'm not a networking guy? :shy:

When I removed the universes from the Network Configuration that didn't actually have hardware associated with them (at least not connected right now), everything worked just like I thought it should. e1.31 traffic out the GbE NIC. And general network traffic over wifi. And nothing crossing over.

Again - a debt of gratitude to all. It's been a pain-in-the-butt to figure it out. But I think I've finally got it.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

but... why did the SACNView test get the same bad results?


Reply
Posts: 213
Topic starter
(@aaron1)
Estimable Member
Joined: 16 years ago
budude wrote:but... why did the SACNView test get the same bad results?

Because I set it up to match the layout in LOR. Which means I was sending traffic to controllers that weren't there.


Reply
Page 8 / 8
Share: