RenC Grinch problem
 
Notifications
Clear all

RenC Grinch problem

4 Posts
3 Users
0 Reactions
1,676 Views
piesrule58
Posts: 443
Topic starter
(@piesrule58)
Honorable Member
Joined: 19 years ago
[#36379]

Hi,
I have given up on my Ren64xb - RenT set up. I just cannot get it to work. So I have gone back to my Grinch - RenC set up. I have used these before in previous shows so I know that everything is connected properly. I know the Grinch works, I know the SSR is ok, the Ren C has power and a heartbeat and all settings in Vixen are correct. The only problem is when I run a sequence there is no Blinky flashy. Any ideas?
Cheers, Terry


3 Replies
Posts: 317
(@dvc2013)
Reputable Member
Joined: 14 years ago

Terry, verify you have a good Zero Cross signal to the Ren-C. Is the ZC led flashing about every second or so ???


Reply
piesrule58
Posts: 443
Topic starter
(@piesrule58)
Honorable Member
Joined: 19 years ago

Problem solved. My show computer has 2 com ports. I took the lead from com 1 and put it into com 2 and bingo, we now have Blinky flashy.


Reply
tweist
Posts: 394
(@tweist)
Reputable Member
Joined: 18 years ago

Terry
Just a thought, but you might want to upgrade to the Ren64Xc or the new Renzilla. Both controllers will work with your current SSR's and are very reliable. And because you can reuse your SSR's the cost to upgrade your controller is a lot less.
Oh and you can use both with wired or wireless communications.
Again, just a thought.


Reply
Share: