Easy way to tell if you have the com port numbers messed up. Disconnect all but one com adapter. Then look at the list of available com ports. The only one there is probably the one you want to test with. Keep in mind that as you add more adapters, move adapters around or reboot, the com port numbers can change.
You guys rock. I set the baud rate to 57600 on COM 1 (using just a serial cable) and the lights came up! Still have to do a full out, all lights plugged in test, but the channels I did test worked beautifully!
Thanks for the help!
Rob,
Now that you have the board working, you mentioned that you had one channel that did not work in your original post. A lot of times when a single channel does not work the optoisolator is in backwards as those little dots are hard to see. You might check that on your bad channel. It is from step 32 - Install 24 optoisolators M1 thru M24 (PN# 859-MOC3023) in the wiki on the SS24.
