Renard controller m...
 
Notifications
Clear all

Renard controller mounting hardware

5 Posts
4 Users
0 Reactions
2,193 Views
Posts: 46
Topic starter
(@frightmaster)
Trusted Member
Joined: 12 years ago
[#42587]

Any assistance where to and what to get for mounting hardware? Currently I have (2) cards I need to mount into an enclosure. For some strange reason, I am brain farting on this.


4 Replies
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

I just buy 1/2" long 4-40 standoffs and use the board to mark the back of the enclosure and drill the holes. It depends on which board and enclosure you have. I just need to get my board above the mounting holes provided in the enclosure. Something similar to these.


Reply
Posts: 46
Topic starter
(@frightmaster)
Trusted Member
Joined: 12 years ago

I am mounting them into a custom enclosure. Just unsure about where to get mounting hardware.

I am using a Ren16 and Ren24 with LAmp cord wired directly to them from my lights. NO PLUGS this year...


Reply
Posts: 110
(@todd1814)
Estimable Member
Joined: 11 years ago

I bought a couple CG1000's for my RP32's but the holes didn't align. I bought a plastic clip board from WalMart, cut off the clip and sanded the edges. The PCB is screwed to the clip board with 6mm screws. I used short pieces of plastic fuel line as spacers. Then I drilled holes to attach the clip board to the CG1000. You could do the same with plexiglass or 1/4" plywood. The clip boards were $1.50 each.

20160926 180115

Reply
MichiganLights
Posts: 479
(@michiganlights)
Prominent Member
Joined: 14 years ago

I used the 1/2" plastic standoffs used for computer mother boards. The Renard boards clip in and are easily removed

http://doityourselfchristmas.com/forums/showthread.php?15287-Ren24SS-in-a-CG2000-pics&p=279475#post279475


Reply
Share: