Renard 64XC problem...
 
Notifications
Clear all

Renard 64XC problems

9 Posts
5 Users
0 Reactions
2,476 Views
Posts: 12
Topic starter
(@azcomp)
Active Member
Joined: 16 years ago
[#17326]

I have built a new Ren64XC board and I'm having some problems. I can get the diagnostic firmware working, but sometimes it takes moving the board or touching the board to make it work. I have not been able to get operational firmware to work. Can I put just 1 operational PIC in while debugging? If anyone has any suggestions I would appreciate it, I'm getting nervous about this.


8 Replies
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

If touching the board or moving it makes it work or not work, then you've probably got a loose connection or short.

I would inspect all your solder joints and even perhaps reheat them to make sure things are OK.

You can just put in one PIC to see what's happening, but then only the first few channels will work.

Pictures of the board always help in narrowing down issues as well.

Also, what size/voltage transformer are you using to power the board? Are the channel LEDs installed?


Reply
Posts: 12
Topic starter
(@azcomp)
Active Member
Joined: 16 years ago

The transformer is the one shipped with the coop group buy ran by Chris Foley. On his site it's listed as 115V/6.3VAC, 1A. I would have to check to see the exact one I have(not at home right now). I did try to re-flow a bunch of solder joints, but that didn't seem to change the behavior.


Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Re-check the screw downs for the incoming power?


Reply
Posts: 12
Topic starter
(@azcomp)
Active Member
Joined: 16 years ago

Well, I have taken out the power leads a few times as I have been checking over the board.:hmm:


Reply
Page 1 / 2
Share: