Notifications
Clear all
Nov 01, 2014 2:50 pm
What software are you using for your testing?
Nov 01, 2014 2:51 pm
Vixen
Nov 01, 2014 3:09 pm
Have you checked that you have a signal with say another Renard board? Perhaps you can do what I did and load xLights and set your test up in there. I haven't used Vixen 3, but I used to use previous versions.
Nov 01, 2014 3:12 pm
This is the only board i have. I am just getting started with it but not starting to good.
Nov 01, 2014 3:30 pm
Perhaps you don't have Vixen configured right. If you bought your kit the Pics should have been flashed already. I would download xlights. It's easy to setup.
Nov 03, 2014 11:40 pm
Well, problem solved and board working. Would like to thank everyone who helped with their input. Had an eeprom in backwards and a few cold solder joints on the lights themselves.
Page 2 / 2
Prev
