Ren24dc problems
 
Notifications
Clear all

Ren24dc problems

16 Posts
4 Users
0 Reactions
4,143 Views
Posts: 11
Topic starter
(@jking7988)
Active Member
Joined: 13 years ago
[#33397]

Is there any way to diagnose a ren24dc? I have recently programmed my pics and connected my ren24 via rs232 and i have no response on any channels. Pics have been wiped twice and verified successfully but i have not seen any info on a diagnostic for the 1825's. Just wondering if anyone had any info?


15 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Which code did you use to program the Ren24DC? Do you have a voltmeter to make some measurements? Is the power supply OK, etc?


Reply
Posts: 11
Topic starter
(@jking7988)
Active Member
Joined: 13 years ago

I used the renard_1825 asm from here on the forum. I do have a voltmeter and the test point on the board and other circuitry all test at 5.0v. I am using a smaller amp power supply but i only have 6 leds attached to each of the first 12 channels. I do not have the second side of the board powered.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
jking7988 wrote:I used the renard_1825 asm from here on the forum. I do have a voltmeter and the test point on the board and other circuitry all test at 5.0v. I am using a smaller amp power supply but i only have 6 leds attached to each of the first 12 channels. I do not have the second side of the board powered.

Sorry - which file exactly? There is a Renard 1825 code for AC based controllers - you need modifications for DC control.


Reply
Posts: 11
Topic starter
(@jking7988)
Active Member
Joined: 13 years ago
Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Don't mean to hijack, but is a buzz or whine normal with these triacs when dimming?


Reply
dlovely
Posts: 3167
(@dlovely)
Famed Member
Joined: 17 years ago
jking7988 wrote:Is there any way to diagnose a ren24dc? I have recently programmed my pics and connected my ren24 via rs232 and i have no response on any channels. Pics have been wiped twice and verified successfully but i have not seen any info on a diagnostic for the 1825's. Just wondering if anyone had any info?

Make sure on the 2nd unit as per the Wiki JP5 has a jumper on pins 4/5.


Reply
dlovely
Posts: 3167
(@dlovely)
Famed Member
Joined: 17 years ago
scootchu wrote:Don't mean to hijack, but is a buzz or whine normal with these triacs when dimming?

The MOSFETs should not make any noise. Are you sure its not a power supply making the noise?


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

I will have to see and listen a little closer. It happen when I was testing and dimming with xlights. Full intensity is quiet.


Reply
Posts: 11
Topic starter
(@jking7988)
Active Member
Joined: 13 years ago

All jumpers are in place. I think that i am just not getting a signal coming through the rs232. Is the cable something that can be checked with a voltmeter? And if so what would the range be?


Reply
Page 1 / 2
Share: