Ren-C not receiving...
 
Notifications
Clear all

Ren-C not receiving data?

2 Posts
2 Users
0 Reactions
1,193 Views
Posts: 9
Topic starter
(@ericwebb)
Active Member
Joined: 19 years ago
[#9739]

Hi all,
Attempting a last-minute conversion of my Olsen 595's using two Ren-C 2.4's and a homemade Ren-T. The 595's are known good, and tested. The Ren-C's were constructed last year and programmed with the standard release 2007 code, but I have also tried the (beta?) 2009 code floating around here on the forum. The Ren-T was a home etch, and I've re-touched and ohmed everything. All appears good solder-wise.

So everything powers up, and the Ren-C/Ren-T rewards me with a heartbeat indicating ZC is good. My Vixen box has two USB-RS232 adapters, both tested good with my Ren24's. Once I connect all the comm, I don't see any Rx activity on the Ren-C boards. Both boards behave the same way (heartbeat, power, no Rx, no framing err, no overrun).

I didn't install the shunts on the Ren-T to bypas 485 conversion, but willing to give it a try.

My questions:
1. Heh, any ideas? 🙂
2. Will the Ren-C natively accept both RS-485 and RS-232 input?


1 Reply
RavingLunatic
Posts: 1502
(@ravinglunatic)
Noble Member
Joined: 19 years ago
ericwebb wrote:
I didn't install the shunts on the Ren-T to bypas 485 conversion, but willing to give it a try.

My questions:
1. Heh, any ideas? 🙂
2. Will the Ren-C natively accept both RS-485 and RS-232 input?

Yes, the Ren-C can accept RS-232

Make sure you have the correct RS-485 chip on the Ren-C, it is a 65LBC179 which is different from the ones used on your Ren24.

A more adventurous thing to try would be to hook your Ren-T output to RS OUT connector on the Ren-C. This would allow the ZC from the Ren-T to still work. Use the same cable that is working on your Ren24 and connect it to the RS IN connector on the Ren-C.


Reply
Share: