Power distribution ...
 
Notifications
Clear all

Power distribution problems HELP!

3 Posts
3 Users
0 Reactions
1,467 Views
Posts: 31
Topic starter
(@greene22)
Trusted Member
Joined: 12 years ago
[#34922]

I am trying to wire up my board to my sockets but I'm confused on how to wire the outlets to power and to the board. I know I can't use a junction box because then all the channels would be messed up. So I was thinking does the power run just through the board and the sockets are powered from each individual channel plug in the board? I'm just using 16 channels so if anyone has a simple diagram that would be great. I need help please. Thank you.


2 Replies
OregonLights
Posts: 736
(@oregonlights)
Prominent Member
Joined: 16 years ago

Hello Greene22,
I am a bit confused about your question and you didn't mention what kind of controller you have, but in overview the power is fed into the controller using a pigtail like a cut off power cord from something else. If using a Ren16SS the household AC current is fed into the two AC inputs using a jumper between the two inputs (assuming you aren't using full current capacity of the board, in which case you may need to feed in two circuits, but this is rare).

Then the power goes through the controller, is switched and then goes out the 16 channel outputs where normally 16 sockets are wired so you can connect your extension cords to your lights.

There are some great wiring diagrams in the WIKI for the Renard SS series boards.

Hope this helps


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

lets say you have a normal renard ss16

recept

this is your house plug you will see your plug has a big side and small side big is neutral small is hot you will see N and 120 input on your board so put them right way as for out too the channels you should have a N and the channels number side by side there and you use plug ends on there and you can connect your lights into them


Reply
Share: