Odd Ren48LSD Proble...
 
Notifications
Clear all

Odd Ren48LSD Problem

12 Posts
4 Users
0 Reactions
3,542 Views
buymyemu
Posts: 638
(@buymyemu)
Prominent Member
Joined: 16 years ago

Here is what I would try (determine what hardware causes the feedback, maybe you did this):

Start with the LSD at the end as you originally had it
Create a new sequence with only the LSD events, save a copy
Run it, if looks good then..

Copy over the 1/2 of the events from an original sequence (if you have 150 channels, copy 75)
Run it, if you get bad feedback:

Start with the lsd sequence again, run it to make sure it is clean

Copy half of what you originally copied and run again.

If that is still bad, keep cutting in half.

Basically trying to isolate which controller/sequence may be triggering your problem.

OR

Start with LSD sequence only

Copy of 1 SS board's worth of events at a time, running each. When your feedback problems occurs, you should get a closer guess as to what hardware/ what sequence of events are the problem.


Reply
Posts: 261
Topic starter
(@hunter310)
Reputable Member
Joined: 17 years ago

WooHoo! LSD is working as it should now! Thank you to all that threw out suggestions. I couldn't find anything wrong with the LSD board itself, so I ended up relocated the board out of the mass enclosure that held all my yard boxes, and re-routed the comm input to be the first one in the line before the offending SS24s. So now, the LSD enclosure is located about 15' away from where it was, connected in the middle of the chain (but again before the yard enclosures) and connected to the yard enclosure using a shielded cat5 cable.

Obviously I had to re-order Vixen...thanks to BeeJaay for reminding me to re-order the output channel order as well as the profile order. That was my problem before too. I had only changed the profile order ("define new order") not the output order too. Editorial note: There should be a copy function to copy the profile order over to the output order so you don't have to do it twice.

Anyhow, the show is running perfect now. Videos to be recorded tonight since it is blinking and flashing when I tell it to.

Thanks again everyone. Again the camaraderie and helpfulness of this community is fabulous.

Steve E.


Reply
Page 3 / 3
Share: