Thanks for the info, the Phillips surge protector with EMI/RFI fixed my flicker!
This was on 2 Ren24SS (out of 7 total Ren24SS) and 2 Lynx Express (out of 7 total Lynx Expresses) all running wireless DMX data via Lynx EX/RXs to full wave LEDs. The Lynx Expresses have built in 47k snubbers. The problem was more prevalent on certain plugs and fllicker could sometimes be cured by moving to a different circuit.
This year I am having terrible flicker with the firegod system. I am experiencing random flicker on all channels simultaneously. I have 95% LED's and the rest incandescent. Well last year the incandescent had no flicker at all- this year its terrible. And every light flickers in sync with all the others. I have made my own cat-5 but do this regularly and they are all standard wiring scheme. I also am powering the pc module with a 3 amp transformers and swapped the Vreg from 5V to 6V. These all solved most of the issues last year but now its back with vengeance. I just went out and bought a few of the Phillips EMI filters from WalMart and they made a slight if any difference. However, I just read that these must be inserted directly on to the SSR and I have mine just at the plug where they get power( All of my SSR's get power from the same outlet- aside from the roof.) Do I need a separate filter for each SSRez or can I use one for every group of 3 or so? They are all plugged in 3 at a time using standard 6' extension cords that have three sockets on the end.
Thanks, Aaron
My experience was any noise caused by one SSR will just jump to the other if the power doesn't come directly from the EMI surge protector. I actually have each of the following in different counts depending on where I needed power. I am running 8 SSREZs on a 64XC and a combination of 12 REN SSs of different size. My problems didn't get much, much better until EVERYTHING was being filtered. I actually saw problems move as I would add surge protectors to the problem areas.
http://www.walmart.com/ip/Philips-1-Outlet-Surge-Protector/17127162
http://www.walmart.com/ip/Philips-3-Outlet-1020J-Surge-Protector-White/17127149
http://www.walmart.com/ip/Philips-5OL-Surge-Protector-Wall-Tap/17127150
I tested: EMI filter -> 3-port extention -> 3 SSRez -> LED Strings and it did not eliminate all of the flicker, so it is now EMI filter -> SSRez (repeat, repeat, repeat), and now no flicker at all. I should have posted this in my earlier post about testing different setups.
bud29 wrote:Ahh, got ya. event period is 50ms. It's driven by rs485. Connection sequence is below:Computer(RS232)->ren24ss->ren8ss->ren8ss->ren24v3.3->ren24v3.3->ren48lsd
I'm using a powersupply outputing approximately 15vdc. Not sure on name or make, I'll have to check.
Rob
Bud29,
I see you haven't recieved a comment yet. By the looks of your setup it appears you have your ren48lsd at the end of the line. I would try to put them on a different com port so you can see if it something in the data line causing your problem from one or all of the other boards. Try the EMI filters, some people have been having luck with them. Try rerouting some of your power cords.
Jerome
