jcarney
@jcarney
Estimable Member
Joined: Dec 13, 2009
Topics: 26 / Replies: 153
Reply
RE: Vixen 3.6 Set Level not working, on some elements.

My only other option is to go through and replace all set level with pulse on with no change in intensity.

7 years ago
Reply
RE: Vixen 3.6 Set Level not working, on some elements.

That's what I was afraid of. These are the same sequences run the same way as last year and the set level show similar behavior as the OP. All other e...

7 years ago
Reply
RE: Vixen 3.6 Set Level not working, on some elements.

Has this been prompted to the release build yet? I am running into the same issue, not in the preview but in the actual export to FPP. I am running 3...

7 years ago
Reply
RE: Show Editor Won't Select Sequences

I haven't tried the dev build yet but I have narrowed it down. When I create new profiles in different drive locations I get different behavior. At...

8 years ago
Reply
RE: Show Editor Won't Select Sequences

Thank you for the reply but that isn't it. I will try the dev build tomorrow.

8 years ago
Topic
Topic
Replies: 4
Views: 1616
Reply
RE: RGB Pixels White Balance

Thanks for all the suggestions. I am running 4 60 amp power supplies but I don't have a configuration that would allow the adjustments suggested this...

10 years ago
Reply
RE: RGB Pixels White Balance

Bump, Is this even possible? Thanks

10 years ago
Topic
Replies: 7
Views: 2137
Reply
RE: Modular Matrix

I should have been more clear, I am running 2 SanDevice e682 to make this happen. I was looking for vixen tips to make this faster but thank you for t...

11 years ago
Topic
11 years ago
Replies: 6
Views: 2106
Reply
RE: How many channels with Vixen3?

4000 channels. And I am adding another ~1800 this year. Yes most are pixels except ~250

12 years ago
Reply
RE: How many channels with Vixen3?

I have about 4,000 and it runs fine. It is also my primary home machine and doesn't have an issue. However it is a very powerful machine.

12 years ago
Page 1 / 12