Controller Locking ...
 
Notifications
Clear all

Controller Locking Up

14 Posts
7 Users
0 Reactions
3,821 Views
rstehle
Posts: 4348
Topic starter
(@rstehle)
Illustrious Member
Joined: 19 years ago

No, the new to position controller was the one that locked up. In other words, it seems to be the location of the controller in the Com line (#1), rather than the controller itself. I am thinking it may have something to do with the Serial Port expansion card I installed. All of the problems are showing up on Com 4.


Reply
rstehle
Posts: 4348
Topic starter
(@rstehle)
Illustrious Member
Joined: 19 years ago

It's Alive!!!!
Well, after a lot of blood, sweat and tears, my show is finally up and running!!! I had a feeling that the problem was with my Serial Port Expansion Card, so as a last resort, I daisy chained the controllers that were on Com 4 on to Com 3, for a total of 240 channels at 50 ms (the Wiki can officially be changed now) and the sequences run perfectly!!!!!!!! I did have a couple of gremlins to hunt down, turned out to be a couple of fuses (had some wire frames that were pulling over 5 amps when a grouping was on...........bigger fuse fixed that...........)
Thanks so much to the folks that offered ideas, you are a great bunch!!!
Will post photo's soon!!


Reply
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

YAY!!!
What great news!!!
I'm SOOOO happy for you!!!


Reply
Posts: 56
(@monteryjack)
Trusted Member
Joined: 19 years ago

I can confirm too that 240 Renard channels on 1 serial port are working on 50ms!


Reply
Page 2 / 2
Share: