communication issue...
 
Notifications
Clear all

communication issues

8 Posts
6 Users
0 Reactions
2,237 Views
Posts: 60
 kjjk
Topic starter
(@kjjk)
Trusted Member
Joined: 15 years ago
[#34327]

the other night i tested to see if the lights would work properly, and it was a successful test. today i go out and try to work it again for as few miner little touches, and now board number three is not working, here is my set up, board 1 sending data, 2, receiving and sending data, 3 reciving data, what is wrong , or what am i fdoing wrong, i think the local news is going to come and interview me in the next week or so, ............HELP!!!


7 Replies
howards9
Posts: 155
(@howards9)
Estimable Member
Joined: 15 years ago

Check power to board 3


Reply
Posts: 60
 kjjk
Topic starter
(@kjjk)
Trusted Member
Joined: 15 years ago

board 3 has power


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Remove the comm cables from each controller and inspect the RJ45 connector inside and out and look for crossed legs inside the connector or dirt/contamination, etc. If OK, plug the cables back in and run a test sequence. If still not working, give the cable ends a slight wiggle to see if there is a loose connection within the cable to the connector. Other than that, you may want to look at swapping cables around.


Reply
Davor
Posts: 221
(@davor)
Reputable Member
Joined: 16 years ago

First, try to determine which board has the problem. Isolate board 3 from the rest of the display and test it by itself with a different (and known working) cable. If board 3 works fine, do the same with board 2. When you determine which board is causing the problem, take it down to do more testing and inspect it for any abnormalities.


Reply
Page 1 / 2
Share: