I last used my Renard 24SS for a static Halloween Display (Just used the timer function for easy turning on/off at set times). Last night I was trying to figure out my WS2811 strip wired to a PX1. The PX1 worked on its own, using a sequence in Vixen 2 with random intensities on 150 channels. My next test step was to replicate the actual display set up, so I programmed the PX1 PIC accordingly and daisy chained it to my Renard 24SS. Nothing worked, not even my Renard 24SS channels. I had gotten a couple of Com port access denied messages but once those clear, nothing turns on.
The only change I have made to the Renard 24SS since Halloween is cut a new, shorter Cat 5 cord. I left one end as the Renard input with pins 4 and 5 swapped. The other end I aligned the wires like a normal Cat5 connection and crimped on a jack. I even cut this jack off and crimped a new one on after checking the proper wire positions.
I am at a loss right now since I can't turn on a single bulb. 🙁 Not to mention the issues I have with programming the WS2811 strips.
This is interesting. I am also running SS24's, 64XC's and a PX1. I was under the impression the PX1 couldn't be daisy chained with my other boards so I gave it it's own output. This has worked fine for me, so I am wondering if that may be your issue. I could be wrong (and likely I am) but you may try to isolate it and see...
You may also check to make sure your baud rates for all the controllers are the same and your com port settings match. In my case, my PX1 is at 115,200 while my other boards are set to 57,600. I guess this answers why I don't have them daisy chained. 🙂
When you say the com port error is cleared, do you mean you start the sequence and have to clear the error or you resolved the issue. If it is the first, this would stop all data from going to the com port.
Javo wrote:This is interesting. I am also running SS24's, 64XC's and a PX1. I was under the impression the PX1 couldn't be daisy chained with my other boards so I gave it it's own output. This has worked fine for me, so I am wondering if that may be your issue. I could be wrong (and likely I am) but you may try to isolate it and see...You may also check to make sure your baud rates for all the controllers are the same and your com port settings match. In my case, my PX1 is at 115,200 while my other boards are set to 57,600. I guess this answers why I don't have them daisy chained. 🙂
I hope not because then I will be missing key portions of the show this year.
My controllers are at 115,200 too.
ctmal wrote:When you say the com port error is cleared, do you mean you start the sequence and have to clear the error or you resolved the issue. If it is the first, this would stop all data from going to the com port.
It was kind of sporadic. Occasionally Com3 would be denied so I would switch the output to Com6 and it would work. At times it did not so I restarted Vixen 2. I know what you're saying by hitting ok on the message box but that's not how I was clearing the errors.
I'm very frustrated that I have no show right now. I can't even do a static show without any controllers right now because I don't have enough outlets!
EVen leaving the pixel strips disconnected I can't run anything. Once the occasional Com error is fixed, there seems to be no data being sent to the first controller.
Why did you reflash the PX1 PIC to connect to a SS24? Have you tried the S24 on its own?
