Pixel question
 
Notifications
Clear all

Pixel question

5 Posts
3 Users
0 Reactions
2,302 Views
Posts: 125
Topic starter
(@northernwarrior)
Estimable Member
Joined: 10 years ago
[#44979]

I have ws2811 led strips that are 10/30. From my limited understanding that is 10 pixels / 30 leds per m so 50/150 for a 5m roll.

Using ardunio you put in number of leds , so if I put in 50 my whole strip works.

I don't understand that.

Now when I get my picap and use FPP am I using 50 or 150 to determine how many rolls I can use per output ?

Sent from my SM-G386W using Tapatalk


4 Replies
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago

Your strip has 50 controllable units. The software will not care how many LEDs, in your case 150. Just use the 50 as your number. You have to consider 150 LEDs when you calculate power and setup your Xlights or other sequencer model but the controller only sees 50. This is because your strips only have 50 ICs (the little black boxes on your strips).

Sent from my iPhone using Tapatalk


Reply
Posts: 125
Topic starter
(@northernwarrior)
Estimable Member
Joined: 10 years ago
Emuney18 wrote:Your strip has 50 controllable units. The software will not care how many LEDs, in your case 150. Just use the 50 as your number. You have to consider 150 LEDs when you calculate power and setup your Xlights or other sequencer model but the controller only sees 50. This is because your strips only have 50 ICs (the little black boxes on your strips).

Sent from my iPhone using Tapatalk

Thank You !


Reply
Posts: 672
(@pixelpuppy)
Honorable Member
Joined: 12 years ago
Emuney18 wrote:Your strip has 50 controllable units. The software will not care how many LEDs, in your case 150. Just use the 50 as your number. You have to consider 150 LEDs when you calculate power and setup your Xlights or other sequencer model but the controller only sees 50. This is because your strips only have 50 ICs (the little black boxes on your strips).

Well, yes and no. YES there are 50 PIXELS on the strip. NO you will not use 50 as the number for FPP and PiCap. Those settings ask for Channel Count and in this case the number is 150. Each pixel is 3 channels so 50 pixels is 150 channels. But, like you said, it is not based on the number of LED's.


Reply
Posts: 672
(@pixelpuppy)
Honorable Member
Joined: 12 years ago
northernwarrior wrote:...Now when I get my picap and use FPP am I using 50 or 150 to determine how many rolls I can use per output ?
Emuney18 wrote:Your strip has 50 controllable units. The software will not care how many LEDs, in your case 150. Just use the 50 as your number. You have to consider 150 LEDs when you calculate power and setup your Xlights or other sequencer model but the controller only sees 50. This is because your strips only have 50 ICs (the little black boxes on your strips).

Well, yes and no and yes.
YES there are 50 PIXELS on the strip.
NO you will not use 50 as the number to configure FPP and PiCap. Those settings ask for Channel Count and in this case the number is 150. Each pixel is 3 channels so 50 pixels is 150 channels.
YES you will use 50 as the number of Pixels per roll to determine how many rolls per output


Reply
Share: