Notifications
Clear all

Installation

14 Posts
4 Users
0 Reactions
6,116 Views
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

You can use Diskpart to regain the space back,but since you mentioned that your're not that good with this stuf,it may be a little overwhelming. If you do the wrong drive,well...thats bad. SD Formatter use to be able to adjust the size,but I don't see it now. I havenn't used it in a while.
There are a couple programs that can do this,Easeus,Aomei,etc.


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago
theycalmegriswal wrote:Ok, the windows formatted it as a fat 32 but only shows that 3.4gb is available out of a 16gb card.

That sounds like the scenario i've run into where you can't access the whole card from windows. I'd bet if you tried to run diskpart and scan the disks, it would just lock up. Do you have some non-computer device on hand that will format an SD card? A digital camera? Camcorder? Tablet? Some other device? Try sticking it in there and reformatting it there, then bring it to windows and check the size. If it's reasonably close to 32GB (probably 29GB or so) then you can be reasonably sure that the other partitions are gone and will no longer be causing you problems.


Reply
Posts: 44
Topic starter
(@theycalmegriswal)
Trusted Member
Joined: 10 years ago

So turns out I grabbed the wrong file. I never heard of a BBB or beagle device so I was burning that one and trying to install it on my pi. Not happening....lol. Pulled the right file and we are in business. Thank you to everyone who helped. You guys help new guys like me.
I started out trying this in 2016 and went with two dumb RGB controllers and one E1.31 controller. After loosing half my hair and a lot of help from Rupro, we got it. Went to install lights in 2017 and had a ladder mishap that gave me a broken foot and toes...no display. In 2018 I moved to a different state in December...no show. Needless to say, I have only one year under my belt on this, but i felt pretty good about remembering Xlights and even added a mega tree this year.

Thanks again.


Reply
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago
theycalmegriswal wrote:So turns out I grabbed the wrong file. I never heard of a BBB or beagle device so I was burning that one and trying to install it on my pi. Not happening....lol. Pulled the right file and we are in business. Thank you to everyone who helped. You guys help new guys like me.
I started out trying this in 2016 and went with two dumb RGB controllers and one E1.31 controller. After loosing half my hair and a lot of help from Rupro, we got it. Went to install lights in 2017 and had a ladder mishap that gave me a broken foot and toes...no display. In 2018 I moved to a different state in December...no show. Needless to say, I have only one year under my belt on this, but i felt pretty good about remembering Xlights and even added a mega tree this year.

Thanks again.

Ahh.Glad you figured it out.:biggrin: We all try to help anybody who needs it. Bunch of great guys/gals here.


Reply
Page 3 / 3
Share: