Just an FYI: to load Pi image, you must clear the partitions, therefore reformatting that clears the partitions is necessary
I suspect that starting with the noobs card is causing headaches. It's likely preventing windows from seeing the whole card.
Download SD Formatter from the SD Card association. https://www.sdcard.org/downloads/formatter/
Format the card as FAT32. Make sure it formats the whole card and that the whole card is available in the one volume it creates. If it's not, you may have to format the card on a non-windows machine first. I've use a digital camera to get a clean format of the entire card and then take it to windows to finish the process.
I'm not familiar with etcher, I use Win32DiskImager. https://sourceforge.net/projects/win32diskimager/ With a clean formatted card, you can then burn the image to the card.
No you can't just download the image from the PI. The SD card is the only storage, and it's the operating system that you're burning to it. So until you have that done, the pi won't do anything. It's the equivilant of booting your PC with no hard drive. It won't do anything at all.
That is the formatter I have been using. The odd thing is it doesn't give me the options of choosing a fat 32. So once I burn the image on the card and put it back in the pi, the pi should start up and run correct? Sorry if this sounds crazy, I just am totally lost on this part.
that is correct. It should just start and run. It takes a bit longer the first time, but still, it's pretty quick. It's best to do it the first time with an HDMI monitor plugged in so you can see what it's doing and when it's done.
Ok, the windows formatted it as a fat 32 but only shows that 3.4gb is available out of a 16gb card.
