I have tried programming thses on 3 different computers. I am using the software and cable from cheapdmx.com. when i hit the program button it says "module prograed" at the bottom of the screen but then when i read it it gives me a 5 digit number starting with 24 or 25 and the program errors and crashes and it isnt writing the address.
So if anyone knows why this isnt writing or has a way around this, or different software. I have no clue what my problem is, and this should be in my show now if i can get them to work.
Thanks for the help in advance,
Will Richards
Not sure what cable you are using...or better said, what kind of cable/dongle that cheapdmx.com sells.
I have programmed my little white boxes with an LOR dongle. It will program them just fine, but won't read back the address correctly, and can error out much like you mention.
I use the software that dmoore has listed on his website - holidaycoro.com. I bought several of the little dmx boxes from him last year for my coroflakes. Is there a way to tell the program you are using which serial/COM port to use? It's possible that you might have one built into the computer that you are using, and it's not talking to the right cable/dongle that's connected to the controller.
It's also quite possible that the connections from the programmer to the dmx controller could be wrong. You need to be sure that the polarity is right - data+ and data- need to go to the right pin on the connection. Since I haven't seen the cheapdmx.com cable, can't help you on that one...
