I am running Vixen 2.1.4 with J1s driver for E1.31, E680 boards.
The boards run just fine using the test function of the new firmware. The strings sequence like they should.
When I run Vixen and use the light test function (thats what I call it) the first universe (10) functions correctly, however the next universe (11) does not. What does happen is that universe 11 receives data from universe 10.
I know I am doing something wrong. I am attaching screen shots of the setups for driver and E680.
Any input would be warmly appreciated.
Thank you,
Al
OOPs LOADED WRONG FILE SORRY.
Could it be that the start addresses are all 1. I thought it was to be universe 10, start 1, size 432, universe 11, start 433, size 432, and so on through your last universe.
I understand (maybe incorrectly) the start address for each universe is unique. In my case each universe starts at 1 and ends at 432.
I would think that would make the channel order in Vixen consequitive.
I am sure I am missing something.
Thanks for all support.
Al
I think your channel numbering should be universe 10 channel 1 to 432 then universe 11 is channel 433 to 864 then universe 12 starts at 865 etc. you have all universes outputting the same channels
Prof, You are correct, I forgot that the channels in this instance refer to Vixen channels.
I feel very stupid now that I see it working.
Going beyond one E680 I assume the same thing holds true keep increasing the channel count by 432 each time. Changing the IP address of each board.
Thanks for your help I really appreciate it.
Now just have to finish the LED portion of the display.
Best to all for you help.
Al




