Ray DMX Programmer
 
Notifications
Clear all

Ray DMX Programmer

3 Posts
3 Users
0 Reactions
2,146 Views
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago
[#32585]

I have a programmer that I bought to program my 10W RGB floods. I need to reprogram 2 of them. Problem...the up/down buttons aren't working. They are buttons on the programmer board, 4 solder points, one in each corner...is there a way to short two connections and simulate pressing the button?


2 Replies
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

Yes, usually for a switch like that is upper corner to lower corner.


Reply
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

If you connect any NO switch and go diametric corners of pins on the board switch to it, you can't go wrong.

Either pins 1 and 3, or 2 and 4,


Reply
Share: